Longshine LCS-GS9428 - Manual (Page 35)

35
Port Commands
Commands at Port level:
Port Configuration []
Port Mode [] []
Port Flow Control [] [enable|disable]
Port Admin [] [enable|disable]
Port MaxFrame [] [|reset]
Port Statistics [] [clear]
------
#Note: If your want to change maxframe bigger than 1518.
The [Flow Control] should be enabled!
Port Configuration []
Description:
Show the configured and current speed, duplex mode, flow control
mode and admin state for the port.
[]: Port list (Default: All ports).
Port Mode [] []
Description:
Set or show the speed and duplex mode for the port.
[]: Port list (Default: All ports).
[] : Port speed and duplex mode (Default: Show configured
and current mode).
10hdx : 10 Mbit/s, half duplex.
10fdx : 10 Mbit/s, full duplex.
100hdx : 100 Mbit/s, half duplex.
100fdx : 100 Mbit/s, full duplex.
1000fdx: 1 Gbit/s, full duplex.
auto : Auto negotiation of speed and duplex.
Port Flow Control [] [enable|disable]
Description:
Set or show flow control mode for the port.
[] : Port list (default: All ports).
[enable|disable]: Enable/disable flow control (default: Show
flow control mode).