Longshine LCS-8560C1 - Manual (Page 78)

AT Commands for CX81801/CX06833/CX81300/CX06827 Modems Reference Manual
Conexant 102184B
3-38
Defined Values
Character string corresponding to the selected option(s).
0-9 DTMF digits 0 to 9.
* The 'star' digit (tone dialing only).
# The 'gate' digit (tone dialing only).
A-D DTMF digits A, B, C, and D. Some countries
may prohibit sending of these digits during
dialing.
L Re-dial last number: the modem will re-dial the
last valid telephone number. The L must be
immediately after the D with all the following
characters ignored).
P Select pulse dialing: pulse dial the numbers that
follow until a "T" is encountered. Affects current
and subsequent dialing. Some countries prevent
changing dialing modes after the first digit is
dialed.
T Select tone dialing: tone dial the numbers that
follow until a "P" is encountered. Affects current
and subsequent dialing. Some countries prevent
changing dialing modes after the first digit is
dialed.
R This command will be accepted, but not acted
on.
S=n Dial the number stored in the directory (n = 0 to
3). (See &Z.)
! Flash: the modem will go on-hook for a time
defined by the value of S29. Country
requirements may limit the time imposed.
W Wait for dial tone: the modem will wait for dial
tone before dialing the digits following "W". If
dial tone is not detected within the time specified
by S7 (US) or S6 (W-class), the modem will
abort the rest of the sequence, return on-hook,
and generate an error message.
@ Wait for silence: the modem will wait for at least
5 seconds of silence in the call progress
frequency band before continuing with the next
dial string parameter. If the modem does not
detect these 5 seconds of silence before the
expiration of the call abort timer (S7), the
modem will terminate the call attempt with a NO
ANSWER message. If busy detection is enabled,
the modem may terminate the call with the
BUSY result code. If answer tone arrives during
execution of this parameter, the modem
handshakes.