Longshine LCS-8560C1 - Manual (Page 139)

AT Commands for CX81801/CX06833/CX81300/CX06827 Modems Reference Manual
102184B Conexant 3-99
+PMHR - Initiate Modem-on-Hold
This command requests the modem to initiate or to confirm a modem-on-hold procedure.
The modem will return ERROR if modem-on-hold is not enabled or if the modem is in an
idle condition. The modem will return the string response +PMHR: where
is a decimal value corresponding to the status of the modem's hold exchange
procedure as defined below. This response may be delayed depending upon the context
under which the +PMHR command is made, i.e., if the +PMHR is in response to an
incoming modem-on-hold or if it is initiating a request.
Note: If modem-on-hold is enabled but the remote server does not support V.92 then the
modem will always report 0 to show that the hold request is denied.
Syntax
+PMHR
Response
+PMHR:
Decimal number corresponding to the maximum hold time the
server or hold-granting modem will allow.
0 V.92 MOH request denied or not available.
1 MOH with 10 second timeout Granted.
2 MOH with 20 second timeout Granted.
3 MOH with 30 second timeout Granted.
4 MOH with 40 second timeout Granted.
5 MOH with 1 minute timeout Granted.
6 MOH with 2 minute timeout Granted.
7 MOH with 3 minute timeout Granted.
8 MOH with 4 minute timeout Granted
9 MOH with 6 minute timeout Granted.
10 MOH with 8 minute timeout Granted.
11 MOH with 12 minute timeout Granted.
12 MOH with 16 minute timeout Granted.
13 MOH with indefinite timeout Granted.
Result Codes
OK 0-13 in V.92 Mode (+MS=V92)
ERROR Otherwise