Commands, 1 typing commands, 2 at commands – Longshine LCS-8560C1 User Manual
Page 11

4. Commands
Most people use the communication software programs to tell modems what to do. Therefore, you may not
se the commands in this chapter. However, if you prefer to communicate with your modem directly, you can
pe the commands described below.
.1 Typing Commands
* Use the BACKSPACE key to delete typing errors.
and +++) must begin with the AT or at prefix and be entered by pressing the
to execute the V command, you would type ATV and press the
* When you see an n, replace the n with one of the letter or numeric options listed for that command.
.2 AT Commands
A /
A
Dn
D
0-9
P
Pu
) dial
Tone dial
Wait for second dial tone (X3 or higher); linked to S6 register.
le/disable.
E0
1
Enable command echo
p)
ook)
k
u
ty
4
* Every command (except A/
For example, for the En command, you might type ATE1.
*All defaults are based on the &F Hardware Flow Control template load in NVRAM when the modem is
shipped.
4
Re-executes the last issued command. Used mainly to redial.
Go off-hook and attempt to answer a call.
ial
DTMF digits 0 to 9
lse (rotary
T
W
^
Toggles calling tone enab
En
Command Echo
Disable
command
echo
E
Hn
Disconnect (Hang-u
H0
Hang up (goes on-h
H1 Go
off-hoo