Vermont Casting DVR33 - Manual (Page 38)

38
Vermont Castings, Majestic Products: DVR33
10004920
Do not remove the existing window
frame assembly.
Side
panel
Floor refractory panel
Log
Support
Lower
side
support
Adjustable
tab
Lower
side
support
Adjustable
tab
Side
panel
BURNER HOUSING
ASSEMBLY
Back Panel
FP1193
Fig. 52 Install ceramic refractory panels.
Decorative Bay Windows
The original front frame/glass assembly
MUST remain in place when fitting the
bay window kits. The bay window kit fits
over existing front glass.
Bay window kits are available for model DVR33
fireplace.
Installation
1. Remove the existing louvre assembly bottom
complete with the hinges.
2. Remove the louvre assembly top.
3. Assemble the Bay Window Kit according to the
instructions supplied with the kit.
4. Place the 2 pieces of ceramic refractory along the
base of the bay window (Fig. 54).
5. Hang the Bay Window Assembly over the existing
window frame assembly.
6. Reinstall the upper louvre assembly.
Remote Controls
Optional remote control units are available to control
different functions of the appliance (only for RN/RP
models).
Model Function(s) Controlled
MRC1 ON/OFF
MRC2 ON/OFF and Temperature
MRC3 ON/OFF and Temperature control
with a digital display and a
programmable 24-hour clock
IMT Wall-mounted thermostat control
Ceramic Refractory Panels
Ceramic refractory panels are available to line the
firebox area.
Unit Kit Model
DVR33 DVR33CR
Take care when handling the refractory
panels as they are fragile until held in
place and supported.
Installation (refer to Fig. 52 and Fig. 54)
1. Remove the window frame assembly
2. Remove the logs.
3. Place the lower supports for the side refractory
panels on the base of the firebox. Place each
support so that the slotted hole fits over the forward
screw head along the edge of the base.
4. Lay the angular base panels in place on the floor of
the firebox on either side of the burner housing
assembly.
5. Loosely attach the top adjustable tabs to the studs
located in the top of the firebox toward the front
corners.
6. Place the rear refractory panel in place. Locate the
‘small brick’ edge of the panel into the two small
supports on the back panel just above the rear log
support.
7. Slide the side refractory panels into place to hold
the rear panel secure. Adjust the top adjustable
tabs to hold the side panel against the firebox wall
and secure the tab. Repeat the procedure on the
other side.
8. Replace the logs and window frame assembly.
NOTE: For aesthetic purposes, we recommend
aligning the horizontal mortar lines.
Firebox Back
Rear Log Support
Rear Refractory Panel
Rear Panel
Support Brackets
FP1194
Fig. 53 Place the rear panel on rear support brackets.