Longshine COBRA15 - Manual (Page 19)

COBRA15
19 Version: 1.0
2. Hardware setup
Getting Started
This section describes how to install or to replace accessories and component on your COBRA15.
2.1 Pre-installation notice
Before you start installing COBRA15 terminal, please read the following notices carefully.
1. COBRA15 terminal does not support PCI slot.
2. Do not plug in or unplug any interior devices, such as memory module or any function card,
when the system power is still on.
3. For installation and compatibility, DDR3 RAM Module provided by the manufacturer is strongly
recommended.
4. The USB device connector is Hot Swap. Do not plug in or unplug any connectors other than
USB devices when the power is still on.
5. Do not insert or remove any devices or components from COBRA15 while the power is still on.
6. Please make sure that flat touch screen will be well protected by soft pad on working table.
When positioning COBRA15 with display facing downwards.