Lippert Components Bike Rack & Tire Carrier - Manual (Page 4)

The Lippert Tire Carrier has three basic assemblies:
1. Main Assembly – The main structure of the tire carrier. All other
components are either welded to or will attach to this assembly.
The actual component that holds the tire.
2. Tire Bracket – Mounts to pre-existing tire carrier and main
assembly is bolted to this plate.
3. Mounting U-Bolts – Inserted into holes on plate on Main
Assembly and goes around rear bumper of unit.
The Lippert Bike Rack has four basic assemblies:
1. Main Assembly w/Clamping Assembly – The main structure of
the bike rack. All other components are either welded to or will
attach to this assembly. The actual component that holds the
bicycles.
2. Mounting Plate – Mounts to tire carrier and main assembly is
bolted to this plate.
3. Screw Handle – Inserted into hole in Main Assembly and
screws into Mounting Plate to hold Main Assembly to tire carrier.
4. Stabilizing Bracket – Bracket that mounts to rear outer wall of
RV and to tire carrier. Provides stability for Tire Carrier to assist
in bearing the added weight of bicycles to the unit.
PRIOR TO INSTALLATION
Prior to installation of the Lippert Bike Rack & Tire Carrier, follow these
guidelines:
1. Coach should be parked on the most level surface available.
2. Area should be clear of debris and work area clean.
3. Be sure to tighten all fasteners securely.
5