Lippert Components Hydraulic Slideout And Hydraulic Landing Gear (hlg) System - Manual (Page 12)

AUXILIARY OPERATION
The Lippert Hydraulic Slideout and HLG System can be run with auxiliary power
devices like electric drills, ratchet wrenches or cordless screwdrivers. In the
event of electrical or system failure, this manual method of extending and
retracting the jacks can be used. A standard handheld drill is all that is required.
See the instructions below:
1. Remove protective label. (See Fig 3).
2. Using a standard hex bit, insert into auxiliary drive device, i.e.
cordless drill or screwdriver or ratchet wrench.
3. Insert hex bit into coupler found under protective label, Fig. 4
4. Run drill forward or clockwise to extend slideout room and in
reverse or counterclockwise to retract slideout room.
Fig. 3
Fig. 4
12