Lippert Components Level-Up Motorhome Leveling - Manual (Page 7)

Rev: 01.13.2015
Page 7
Level-Up® Motorhome Leveling Troubleshooting Guide
LEVEL-UP
®
MOTORHOME LEVELING
TROUBLESHOOTING GUIDE
Calibration and Programming
Level Zero Point Calibration
Before auto leveling features are available, the Level Zero Point must be set. This is the point to which the
system will return when an auto leveling cycle is initiated.
To set the zero point (controller module must be fully secured in production-intent location) activate the
Level Zero Point configuration mode.
This mode is enabled by performing the following sequence:
1. Turn panel off.
2. Press the FRONT switch 10 times (On Winnebago units, press FRONT 5 times).
3. Press the REAR switch 10 times (On Winnebago units, press REAR 5 times).
4. At this point, a beep will sound and the display reads ZERO POINT CALIBRATION. Do NOT press Enter.
5. Perform a manual leveling sequence on the coach.
6. Press ENTER to set the zero point.
7. Screen will then display Zero Point Stability Check and PLEASE WAIT.
8. Beep will sound and the screen will display ZERO POINT SUCCESSFUL.
9. Control will then turn off.
For Diesel Units with Air Bag Suspensions ONLY
The leveling control will automatically detect an air bag system. If the unit does not use air bags, the display
will read "NO" for air bag control. If the display reads "NO", but an air bag system is present on the unit:
1. Confirm harness is connected properly.
2. Run Auto-Level function.
3. Recalibrate the Zero Point.
4. If the air bag system is still not being detected, contact the OEM for more information.
LEVEL-UP
®
MOTORHOME LEVELING
TROUBLESHOOTING GUIDE