Lippert Components Ground Control 3.0 OEM - Manual (Page 14)

Rev: 01.30.2015 Page 14
Ground Control 3.0 OEM Installation Manual
Touch Pad Error Codes
NoTE: To clear an error from the touch pad, repair or otherwise correct the issue, then press “ENTER.” If the
error is still present, the message will be displayed again.
LCD Message What's Happening? What Should Be Done?
****ERROR****
Excess Angle
Controller not properly secured. Check and secure controller placement.
Excessive angle reached during
auto operation.
Relocate the coach.
****ERROR****
Excessive Angle
Controller not properly secured. Check and secure controller placement.
Excessive angle reached during
auto operation.
Relocate the coach.
****ERROR****
Feature Disabled
Front of coach below level when
starting Auto Level process (only
when trying to initiate Hitch
Recognition).
Raise front of coach above level and
restart Auto Level process.
Touch pad power not cycled
between consecutive leveling
operations.
Turn touch pad off and then back on to
reset the system.
Zero point not set. Set zero point.
****ERROR****
Low Voltage
Battery voltage dropped below
10.8V.
Check wiring for loose connections.
Test battery voltage under load - charge or
replace.
****ERROR****
Out Of Stroke
Jack has reached maximum
stroke length and is unable to lift.
Check disposition of jacks. Relocate the
coach.
****ERROR****
External Sensor
Bad connection or wiring from
the controller to the rear sensor.
Replace or repair connection to rear
remote sensor.
****ERROR****
Jack Time Out
Time limit exceeded for the
requested auto operation.
Check disposition of jacks.
****ERROR****
Auto Level Fail
Unable to auto level due to
uneven ground.
Check disposition of jacks. Relocate the
coach.
Unable to auto level due to zero
point being set incorrectly.
Reset zero point.
****ERROR****
Bad Calibration
Sensor calibration values are out
of range.
Reset zero point.
****ERROR****
Internal Sensor
Internal sensor problem. Replace controller.
**PANIC STOP**
Function Aborted
The user pressed a button on the
touch pad during an automatic
operation.
Restart automatic operation and then
refrain from pressing any buttons on the
touch pad.