LABEC GW1060 - Manual (Page 21)

Rev. 00 GW2045 – GW1060 Manual Pag. 20 di 43
6.2. SETUP MODE DESCRIPTION
The SETUP function can be accessed on the programme selection switch (see par. DATE AND TIME
SETUP).
Note: Below, in brackets, are the numbers used in the picture to identify the controls.
Procedure for accessing appliance’s SETUP menu:
• Press the ON/OFF button (3) to switch on the machine (If any alarm appears on the display at this
stage, ignore it).
• Turn the PROGRAMME SELECTION SWITCH (1) to go to the SETUP position required (see the
description of programmable parameters below).
• Press the DOOR OPEN BUTTON (6) for 4 seconds to enter the setup function Wait for the dual
beep as confirmation.
• To increase a value press "TEMPERATURE VIEWING" (5) parameter must only be viewed and not
changed.
• To decrease a value press START/PAUSE" (4) Do not use this button if the parameter must only be
viewed and not changed.
• TO END PROGRAMMING, press the DOOR OPENING (6) button and keep it pressed for 4
seconds. The new settings are now saved.
• IF YOU WISH TO EXIT THE SETUP MODE WITHOUT SAVING the parameters you may have
changed, do not press the DOOR OPENING (6) button, but turn off the machine using the ON/OFF
button (3).