LAARS Mighty-Stack TL80-199 - Installation, Operation and Maintenance Instructions - Manual (Page 16)

LAARS Heating Systems Company
Page 16
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or
explosion may result causing property damage,
personal injury, or loss of life.
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air and
will settle to the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to move the gas control
switch. Never use tools. If the switch will not
move by hand, don't try to repair it, call a
qualified service technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas
control which has been under water.
TO TURN OFF GAS TO WATER HEATER
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed.
OPERATING INSTRUCTIONS
Honeywell SV9501/9601 Gas Valve
9. Turn on all electric power to the appliance.
10. If the appliance will not operate, follow the
instructions “To Turn Off Gas To Appliance” and
call your service technician or gas supplier.
1. STOP! Read the safety information above on this
label.
2. Set the aquastat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition
device which automatically lights the pilot. Do
not try to light the pilot by hand.
5. Set ignition system control switch to “OFF”.
6. Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow “B” in the safety
information above. If you don't smell gas, go to
next step.
7. Set ignition system control switch to “ON”.
8. Set aquastat to desired setting.
3. Set ignition system control switch to “OFF”
position.