Cadillac 2010 Escalade - Manual (Page 149)

If your vehicle does start, the first key may be faulty.
See your dealer/retailer who can service the
PASS-Key
® III+ to have a new key made. In an
emergency, contact Roadside Assistance.
It is possible for the PASS-Key ® III+ decoder to learn
the transponder value of a new or replacement key.
Up to 10 keys may be programmed for the vehicle.
The following procedure is for programming additional
keys only. If all the currently programmed keys are lost
or do not operate, you must see your dealer/retailer or a
locksmith who can service PASS-Key
® III+ to have keys
made and programmed to the system.
See your dealer/retailer or a locksmith who can service
PASS-Key
® III+ to get a new key blank that is cut
exactly as the ignition key that operates the system.
To program the new additional key:
1. Verify that the new key has a
1
stamped on it.
2. Insert the original, already programmed, key in the
ignition and start the engine. If the engine will not
start, see your dealer/retailer for service.
3. After the engine has started, turn the key to
LOCK/OFF, and remove the key.
4. Insert the new key to be programmed and turn it to
the ON/RUN position within five seconds of turning
the ignition to the LOCK/OFF position in Step 3.
The security light will turn off once the key has
been programmed.
5. Repeat Steps 1 through 4 if additional keys are to
be programmed.
If you lose or damage your PASS-Key ® III+ key, see
your dealer/retailer or a locksmith who can service
PASS-Key
® III+ to have a new key made.
Do not leave the key or device that disarms or
deactivates the theft deterrent system in the vehicle.
3-25