KERN & SOHN HTS 10T-3AM - Manual (Page 8)

2.7 Safe working
 Do not stand underneath suspended loads!
 Position the crane in a way that the load is lifted vertically.
 When working with the crane and crane scales wear personal safety equipment
(helmet, safety shoes etc.).
2.8 Monitoring of Test Resources
In the framework of quality assurance the measuring-related properties of the
balance and, if applicable, the testing weight, must be checked regularly. The
responsible user must define a suitable interval as well as type and scope of this test.
Information is available on KERN’s home page (www.kern-sohn.com) with regard to
the monitoring of balance test substances and the test weights required for this. In
KERN’s accredited DKD calibration laboratory test weights and balances may be
calibrated (return to the national standard) fast and at moderate cost.
2.9 Testing upon acceptance
When receiving the appliance, please check packaging immediately, and the
appliance itself when unpacking for possible visible damage.
2.10 Initial Commissioning
In order to obtain exact results with the electronic balances, your balance must have
reached the operating temperature (see warming up time chap. 1).
During this warming up time the balance must be connected to the power supply
(mains, accumulator or battery).
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter Adjustment.
For checking original dimensions, s. chap. 4.2
2.11 Shutdown and storage
 Take off the crane scales from the crane and dismantle all load attachment
devices from the crane scales.
 Do not store the crane scales at open air
HTS_A-BA-e-1430 8