KERN & SOHN HTS 10T-3AM - Manual (Page 20)

5.3 Turn on/off
Start-up

Press on the keyboard of the balance. The display lights up and the balance
carries out a selftest. The display runs through “PoUP2
„ESC2“„8.8.8.88“,
followed by the battery loading status (e.g. “CH5“ corresponds to a battery loading
status of 50%) and the check number of adjustments. The selftest is completed
when the weight value 0 appears on the display.
Battery loading status:
The battery loading status is represented in the form of “CH .x“, such as
This corresponds to a battery loading status of 90%.
Check number:
For verified balances pay attention to check number!
The check number will be shown after the balance has been turned on. This
number will be adjusted automatically after each adjustment activity. In
verified balances this number is an integral part for conformity evaluation.
This allows you to check at any time whether new adjustment has been
carried out.
To display the check number, turn the balance off and then restart it with . The
display shows successively e.g.:
8.8.8.8.8 Check LCD segments
CH .9 Battery loading status (example: CH .9 corresponds to a battery
loading status of 90%
8985 Check number
• Switching on/off only possible on the keyboard of the balance.
• Using the remote control unit, the balance can only be switched on from
the standby mode.
HTS_A-BA-e-1430 20