KERN & SOHN FCE 30K10N - Manual (Page 12)

FCE-N-BA-e-1220 12
7.2 Weighing
Operation Display
 Start balance by pressing
The balance displays for approx. 3 seconds [88888]
and then goes to [0]. Now it is ready for operation.
 Only now (!) place goods onto weighing plate.
Take care that the weighed material does not touch the balance housing or the
base mat.
Now the weight is displayed, after the standstill control
appears the weighing unit [g] right-hand in the display.
(Example)
If the material to be weighed is heavier than the weighing
range, the display will show [Error] (=Overload).
7.3 Taring
Operation Display
 Switch on balance by pressing
and wait for the
[0] display.
 Place the tare vessel on the weighing plate and press
the button. The balance display goes to [0].
 Put the sample into the tare vessel.
The weight of the sample will be displayed.
(Example)
 If after finishing the weighing process the
button is
pressed again, [0] appears anew in the display.
The taring process can be repeated any number of times, e.g. when adding several
components for a mixture (adding).
The limit is reached when the whole weighing range is exhausted.
After removing the taring container the total weight is displayed as negative display.
By pressing anew the
button, the balance will go back to „0“.