Kenton Spin Doctor - Manual (Page 14)

dMP Dump a Spin Doctor profile
This mode allows you to dump complete profiles into another Spin Doctor, a
Kenton Control Freak or a data librarian package. In this way you can store your
own custom presets on your computer, to be loaded back into Spin Doctor as
required.
Initially, the display will show d XX (where XX is the last program selected, from
0-24). You can use the DATA ENTRY knob to change this to whichever
program location you wish to dump from.
When you have selected a program, press the F.KEY to send the dump. While
the dump is being sent, the display will show – – – – but the MIDI OUT and
SysEx indicators will not light. The display will revert to d XX when the dump has
been transmitted.
The knobs operate as normal in this mode.
Edit Edit a knob to send the controller number of your choice
This mode allows you to assign any MIDI continuous controller number 0-127 to
any knob in any program. In this way you can control any piece of MIDI
equipment that responds to controller messages. You will need to use
PSEL
mode to select the program to edit (see page 10).
Initially, the display will show EdXX (where XX is the last knob moved, from 1-
16). If you want to edit a different knob, simply turn the DATA ENTRY knob to
select a different knob number. Then, turn the corresponding knob to select the
controller number you wish to assign. Knobs other than the one selected will do
nothing.
When the display is showing the controller number you wish to assign, press the
F.KEY to store your selection. The display will then revert showing EdXX.
Neither the knobs, nor the F.KEY will send any MIDI data in this mode.