Kenton Spin Doctor - Manual (Page 13)

ScrL Scroll speed adjustment for scrolling text (default: 6)
This mode allows you to adjust the scroll speed for the text being displayed by
Spin Doctor.
Use the DATA ENTRY knob to change the scroll speed from 1-16, where 1 is the
fastest and 16 is the slowest. Press the F.KEY to store your selection – display
will read Stor.
The knobs operate as normal in this mode.
MAP Map incoming profiles to the program location of your choice
This mode allows you to specify the program location that a profile will load into.
All pre-programmed profiles carry within them the program number for which
they are destined, to enable the software editors to work effectively. You can
override the allocated program number and make profiles load into the program
location of your choice. In some cases this is essential, as Spin Doctor will
ignore any profile with an allocated program number that is higher than 24.
Initially, the display will show MXX (where XX is the last program selected, from
0-24). You can use the DATA ENTRY knob to change this to whichever
program location you wish to map to. If you change the mapping location, the
current program will change to the same number.
When you have selected a program you can load a profile in the usual way.
While the profile is being received, the MIDI IN indicator will light and the SysEx
indicator will flash.
The knobs operate as normal in this mode, but the F.KEY will do nothing.
Notes:
1) Spin Doctor can only use the knob/slider parts of the data and will ignore
any button data from Control Freak profiles. Please be aware of this when
loading profiles from a Control Freak into Spin Doctor, or vice-versa.
When dumps are transmitted to a Freak Studio Edition or Live, Spin
Doctor will transmit button data for compatibility, but will transmit empty
button data.
2) MAP mode also works with individual knob assignments, although you
can only specify the program location, not which knob they will load into.