Kenton Pro-Solo mk1 - Manual (Page 9)

It may be that your synth is slightly out of tune, so it will be necessary to tune the PRO
SOLO to your synth.
1, Firstly, ensure that your analogue synth is in tune when playing from its own keyboard.
Do this by adjusting the tuning or pitch knob on your analogue synth whilst playing middle
C on both this and your master keyboard (or whatever you use for tuning reference). To
do this, you may need to disconnect the analogue synth from the PRO SOLO.
2, Connect the converter to your analogue synth and MIDI system. Check the PRO SOLO
is switched to the correct scaling system, Hz/V for Korg and Yamaha, or V/oct for anything
else (see Editing Parameters section). Set transpose to zero. Now press bottom C (MIDI
note #36) on your digital synth. Both synths should sound, don’t worry at this stage if they
are not in tune.
3, Using bottom C (MIDI note #36) as a reference (you must use this note for maximum
accuracy) tune in the PRO SOLO with your analogue synth by adjusting the parameter
FINE TUNE and TRANSPOSE if necessary (see Editing Parameters section) until it is exactly in
tune.
4, When your digital & analogue synths are in tune at the bottom , play middle C, two
octaves up on your digital synth. (MIDI note #60). Now adjust the SCALE parameter (see
Editing Parameters section) until both synths are in tune. The analogue synth should now
play correctly across it’s complete range from your master keyboard, if this is still not the
case go back to step 3 and repeat the process for final tweaking.
1- Make sure all cable connections have been made.
2- Set MIDI receive channel you wish to use.
3- Make sure you have set the GATE output correctly to either `Gate`
or `S-Trig` type triggers.
4- Make sure you have set the CV output correctly to either `V/oct`
or `Hz/V.`
5 - You may wish to adjust the AUX, or any other settings to those that
work best for your set-up.
Power on the PRO SOLO whilst holding the INC and DEC buttons pressed and the
software revision [43xx] and build number [0xxx] will be displayed. Releasing the buttons
will revert to the normal operational mode.
TUNING IN THE PRO SOLO & ANALOGUE SYNTH
CHECK LIST FOR SETTING UP THE PRO SOLO
DISPLAYING THE SOFTWARE VERSION