Kenton Pro-Solo mk1 - Manual (Page 6)

7 Portamento controller number (default: 65)
- Sets which MIDI controller will turn on/off the portamento function.
The following can be selected;
On [on] always on
Off [of] always off
Program change [PC] program 1=on program 2=off
MIDI controllers #0 to 120 values above midway=on, below midway=off
The standard MIDI controller for portamento on/off is 65 which is the default, but with this
command , the PRO SOLO allows you to use another controller or a program change or
direct control if you wish.
8 AUX controller number (default: 16)
- Sets which MIDI controller will control the auxiliary output.
The following can be selected;
Trig Pulse [tr]
Off [Of]
Pitch bend [Pb]
Velocity [VL]
Aftertouch [Af]
MIDI controllers 0-120
If trig pulse is selected, the aux output will send a short trigger pulse whenever a valid
new MIDI note is received – this can be used to drive the envelope generator on synths
that require a separate trigger for this. (Only usually needed by the Arp 2600 and a few
modulars)
9 AUX minimum value (default: 0)
Range -27 to +100
- Sets the level for the Auxiliary output when the MIDI controller source is at its minimum.
A AUX maximum value (default: 100)
Range -27 to +100
- Sets the level for the Auxiliary output when the MIDI controller source is at its maximum.
b AUX reset value (default: 0)
Range -27 to +100
- Sets the level the Auxiliary output will reset to when the PRO SOLO is powered on and
when it receives a controller reset MIDI command.
Note that minimum can be set above maximum so that the controller works backwards.