K-Edge K13-530-[color] - Manual (Page 4)

4
WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!
Troubleshooting:

My mount hits the stem during installation, regardless of head angle.
o A spacer may be needed below the mount to clear the stem.

My computer (Forerunner® 910XT) hits the K13-530 during installation.
o Contact K-Edge for a spacer to properly space your 910XT.

There is a little play even when my computer is installed onto the mount with a positive click.
o With the computer installed, visually check for movement of the K13-503 from the openings underneath the
mount. If movement is detected slightly increase the torque of the 2x M3 x 6mm Flat Head Screws (1 N-m
Max).
 The mount rotates about the steerer tube when I install my computer.
o Check that the proper amount of torque is applied to the top cap bolt.
Support/Contact:
If problem(s) still persist after troubleshooting, please contact K-EDGE Support for further assistance at [email protected]
immediately. Please be sure to include your full name, phone number, and K-EDGE product purchased.