K-Edge K13-010-31.8 - Manual (Page 3)

2. Attach chain catcher to the clamp and lightly tighten.
3. Center the clamp on the seat tube and check for proper clearance of chain catcher from the chain, chainring and
chainring bolts. Leave about 0.5mm clearance between chain catcher and chain. See image below:
4. Using a 3mm Allen key, tighten chain catcher. Do not exceed 2 N-m.
5. Using same 3mm Allen key, tighten chain catcher. While tightening, it will be necessary to apply slight pressure to the
chain catcher to keep it from rotating towards the chainring. Tighten to 2 to 3 N-m.
6. Using a 1.5mm Allen key, tighten the small set screw until it impacts the K-Edge clamp.