Clarion PE-2322B - Manual (Page 17)

16
ADX5655z
280-7452-00
Other Handy Functions
1. Press and hold ADJ button # for 1 second or
longer to switch to the adjustment selection
display.
2. Press Right button ¥ or Left button % to se-
lect “ANA SENS”.
3. Press Up button & or Down button * to set
the sensitivity of the spectrum analyzer.
You can choose one of “LOW”, “MID” or
“HIGH” for the sensitivity of the spectrum ana-
lyzer.
4. Press ADJ button # to return to the previous
mode.
Setting the speed of the spectrum
analyzer display
∗
The factory default setting is “HIGH”.
1. Press and hold ADJ button # for 1 second or
longer to switch to the adjustment selection
display.
2. Press Right button ¥ or Left button % to se-
lect “ANA SPD”.
3. Press Up button & or Down button * to set
the speed of the spectrum analyzer display.
You can choose one of “LOW”, “MID” or
“HIGH” for the speed of the spectrum analyzer
display.
4. Press ADJ button # to return to the previous
mode.
Entering titles
Titles up to 10 characters long can be stored in
memory and displayed for radio or TV stations
and CDs. The numbers of titles that can be
entered for each mode are as follows.
1. Press FUNC button 7 to select the mode you
want to enter a title. (radio, CD, CD changer or
TV)
∗
Titles cannot be entered for MDs with this unit.
2. Select and play a CD or a CD in the CD changer,
or tune to an appropriate TV or radio station.
3. Press DISP button 3 and display the title.
Setting the clock
1. Press and hold ADJ button # for 1 second or
longer to switch to the adjustment selection
display.
2. Press Right button ¥ or Left button % to se-
lect “CLOCK”.
3. Press ENT button @ .
4. Press Right button ¥ or Left button % to se-
lect the hour or the minute.
5. Press Up button & or press Down button *
to set the correct time.
∗
The clock is displayed in 12-hour format.
6. Press ENT button @ to store the time into memory.
7. Press ADJ button # to return to the previous mode.
Note:
• You cannot set the clock when it is displayed with
only the ignition on. If you drain or remove the car’s
battery or take out this unit, the clock is reset. While
setting the clock, if another button or operation is
selected, the clock set mode is canceled.
Switching the spectrum analyzer
display patterns
You can select one out of 4 patterns or set it to
off.
∗
The factory default setting is “PATTERN 1”.
Each time you press SPE-ANA button 4 , the
spectrum analyzer display pattern changes in the
following order:
PATTERN 1 ➜ PATTERN 2 ➜ PATTERN 3 ➜
PATTERN 4 ➜ PATTERN 5 ➜ PATTERN 6 ➜
PATTERN 7 ➜ PATTERN 8 ➜ PATTERN 9 ➜
OFF ➜ PATTERN 1...
Note:
The spectrum analyzer display is unavailable dur-
ing these operations below;
• Seek tuning and auto store in radio mode.
• Mute or pause.
• When “NO DISC” or an error message appears
in the display.
Setting the sensitivity of the spec-
trum analyzer
∗
The factory default setting is “MID”.
CD changer mode Number of titles
CDC655z connected 60 titles
CDC655Tz connected 100 titles
CDC1255z connected 50 titles
Mode Number of titles
Radio mode 30 titles
CD mode 100 titles
TV mode 15 titles