Clarion PE-2322B - Manual (Page 10)

280-7452-00
ADX5655z
9
6. OPERATIONS
Basic Operations Note: Be sure to read this chapter referring to the front diagrams of
chapter “3. CONTROLS” on page 5 (unfold).
CAUTION
Be sure to lower the volume before switching
off the unit power or the ignition key. The unit
remembers its last volume setting. If you
switch the power off with the volume up, when
you switch the power back on, the sudden
loud volume may hurt your hearing and dam-
age the unit.
The clock is displayed when the ignition key
is turned to the ACC (accessory) or IGN (igni-
tion-on) position even when the unit power
is off. In some cars, the clock may momen-
tarily disappear when the ignition key is
turned to the START position. The clock will
reappear after the engine has started and the
ignition key is released to the IGN (ignition-
on) position.
Turning on/off the power
Notes:
• Be careful about using this unit for a long time with-
out running the engine. If you drain the car’s bat-
tery too far, you may not be able to start the en-
gine and this can reduce the service life of the
battery.
• System check
This unit checks what external equipment is con-
nected to the CeNET. The first time the ACC/Igni-
tion is turned on (initialization), “SYSTEM” and
“Push PWR” alternately blink in the display. Press
POWER button
7 to start the system check. When
complete, press POWER button 7 again to acti-
vate the unit then the unit appears CHECKING
COMPLETE.
1. Press POWER button 7 .
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold POWER button 7 for 1 sec-
ond or longer to turn off the power for the unit.
Selecting a mode
1. Press FUNC button 7 to change the mode
of operation.
2. Each time you press FUNC button 7 , the
mode of operation changes in the following
order:
Radio mode ➜ CD mode ➜ Tape mode ➜
CD changer mode ➜ MD changer mode ➜
TV mode ➜ Radio mode...
∗
External equipment not connected with CeNET
is not displayed.
Adjusting the volume
Press Up button & or Down button * increases
or decreases the volume.
∗
The volume level is from 0 (minimum) to 33 (maxi-
mum).
Switching the display
Press DISP button 3 to select the desired dis-
play.
Each time you press DISP button
3 , the display
switches in the following order:
Main display
Sub (title) display
Clock display
Main display...