Cardo SCALA RIDER G4 User Manual

Page 9

gli

Thanks to MDC technology each G4 offers parallel connectivity as

follows*:

➤

Intercom with up to two other scala rider units

➤

Bluetooth enabled Mobile Phone / GPS device

➤

A2DP enabled MP3 Player or A2DP Adapter

NOTE: If you plan to use your mobile phone while using a Bluetooth GPS

device, then you should pair your mobile phone to the GPS and not to the G4.

* see restrictions under 9.10 b

6.1 MOBILE PHONE
To use your mobile phone with the scala rider G4, you must

first pair the G4 to your mobile phone.
Pairing is a one-time process. Once the G4 is paired to a

specific mobile phone, they will remain paired and automatically

recognize each other whenever they are within range.
If the connection between the phone and G4 is lost, tap the Mobile

Button on your G4 to reconnect the devices.
PAIRING THE G4 TO A BLUETOOTH MOBILE PHONE:
1. Turn on your phone and make sure its Bluetooth function is activated.

Turn on your G4 by pressing the Mobile Button for at least four

seconds resulting in three blue flashes.

2. With the G4 turned ON, press and hold the Mobile Button for

at least six seconds until the Red and Blue Lights begin rapidly

alternating.

3. Search for Bluetooth devices on your phone by following the phone’s

instructions. Consult your phone’s User Manual for more information.

4. After a few seconds the phone will list “scala rider G4” as a

discovered device. Select it and follow your phone’s instructions to

accept the pairing.

5. When prompted, enter 0000 (four zeros) as your PIN or passkey.

6. Your phone will confirm that pairing has succeeded and the G4 will

begin flashing slowly in Blue.

NOTES:
• If the Pairing process is not completed within two minutes, the G4 will return

to Standby mode.

• Not all Bluetooth mobile phones can broadcast Bluetooth Stereo music

(A2DP), even if the phone has an MP3 player function. Consult your mobile

phone’s User Manual for more information.
• With some mobile phones, you may need to tap the Mobile Button

to connect the G4 to the phone after pairing is complete. The G4 will

automatically connect to the last phone it is paired with.

6.2 GPS DEVICE
To use a Bluetooth enabled GPS device with the

scala rider G4, the two must first be paired. This will

allow your GPS to transmit navigation instructions and audio to the

speakers of your G4.

NOTE: Not all Bluetooth enabled GPS devices allow connections to

Bluetooth headsets or communication systems. Among others, any

such GPS unit must be compatible with the Bluetooth “Handsfree”

gateway protocol. Please consult your GPS device’s User Manual for more

information.

PAIRING THE G4 TO A GPS DEVICE:
1. Turn on your GPS.
2. With the G4 turned ON, press and hold the Volume Up Button for

at least six seconds until the Red and Blue Lights begin flashing

simultaneously.

3. Search for Bluetooth headsets on your GPS device by following the

device’s instructions. Consult your GPS device’s User Manual for

more information.

scala rider

PowerSet