Support, Important, Notices – Cardo SCALA RIDER G4 User Manual
Page 23

En
gli
sh
General Functions
Category
Desired result
Required Action
Making Click-to-Link
calls
Start a Click-to-Link call
request*
Double tap Channel “A”
Button
Cancel a Click-to-Link call
Tap Channel “A” Button
Receiving Click-to-
Link calls
Accept a Click-to-Link call When you hear the ring-
tone, tap Channel “A”
Button or speak loudly
to answer by VOX
Reject a Click-to-Link call
When hearing the ring
tone, remain silent for 10
seconds or until the ring
tone subsides
During Click-to-Link
calls
End a Click-to-Link call
Tap Channel “A” Button
* The G4 searches for another Click-to-Link enabled unit for up to 10 seconds, while
beeping and flashing red.
NOTE: Click-to-Link connections will not replace or change your current Rider
A and Rider B intercom pairings. Click-to-Link uses a separate temporary
channel to connect to a Click-to-Link conversation partner.
11. SUPPORT
For additional information please visit our website at
FAQ:
or contact us at: [email protected]
Phone:
USA and Canada: 1-800-488-0363
International: +4989 450 36819
IMPORTANT
MULTINATIONAL ELECTRONIC COMMERCE COMPANIES AND
ONLINE AUCTION WEBSITES ARE NOT AUTHORIZED TO SELL
CARDO PRODUCTS. ANY PURCHASES FROM SUCH SITES ARE
AT YOUR OWN RISK. TO RECEIVE WARRANTY OR CUSTOMER
SERVICE, YOU MUST SUBMIT ORIGINAL RECEIPTS FROM
AUTHORIZED CARDO DEALERS.
PRODUCTS THAT WERE IMPORTED FROM NORTH AMERICA
MUST ALSO BE SERVICED THERE.
12. NOTICES
Federal Communications Commission (FCC) / Industry Canada (IC)
Statement
15.21
You are cautioned that changes or modifications not expressly approved by
the part responsible for compliance could void the user’s authority to operate
the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC / IC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
23
scala rider
®
G4
PowerSet