Cardo SCALA RIDER G4 User Manual

Page 20

9.11 USING THE G4 FOR INTERCOM WITH OTHER

SCALA RIDER MODELS
9.11a. TWO-WAY INTERCOM with scala rider Q2/Q2

pro

To use your G4 with a Q2 unit, we recommend that you also refer to

your Q2 manual.
1. If either device is turned OFF, turn it ON by pressing and holding

either the Mobile Button for the G4 unit or the CTRL Button for the

Q2 until the Blue Lights flash three times.

2. Make sure that both devices are now flashing slowly in Blue.
3. On the G4, select an available CHANNEL to pair the Q2 (CHANNEL

“A” or CHANNEL “B”).

NOTE: Selecting a CHANNEL that is already in use will replace the paired

device on that CHANNEL with the newly paired headset.

4. On the G4, press and hold the assigned CHANNEL BUTTON (“A” or

“B”) for at least six seconds until the G4’s BLUE or RED Light begins

flashing rapidly, indicating it is in Intercom Pairing mode (See Table

in 9.10).

5. On the Q2, simultaneously press and hold the CTRL and MC

Buttons until the RED Light begins flashing rapidly, indicating it is in

Intercom Pairing mode (see Q2 manual).

6. Within a few seconds, both units will show a solid light for two

seconds, indicating that they are now paired, connected and ready

for use.

NOTES:

• If the Pairing process is not completed within two minutes the units will

return to Standby mode.

• Voice Connect Intercom can only be initiated from the G4/Q2

pro

However, you can always initiate the Intercom manually also from a Q2

unit by pressing the button.

9.11b. TWO-WAY INTERCOM WITH EARLIER SCALA RIDER

MODELS
To use your G4 with other scala rider models such as the “Solo”,

“FM”, "TeamSet

pro

" or a “TeamSet” Driver unit make sure you have the

manual of the other scala rider headset available.
1. While the G4 is turned OFF, turn it ON by pressing and holding the

Mobile Button until the Blue Light flashes three times.

2. Turn the other scala rider ON by pressing and holding its CTRL

Button until the Red/Blue lights begin rapidly alternating.

3. For the G4, select an available CHANNEL to pair the other unit

(CHANNEL “A” or CHANNEL “B”).

NOTE: Selecting a CHANNEL that is already in use will replace the paired

device on that CHANNEL with the newly paired headset.

4. On the G4, press and hold the assigned CHANNEL BUTTON (“A”

or “B”) for at least six seconds until the BLUE or RED Light begins

flashing rapidly, indicating it is in Intercom Pairing mode. (See 9.10

Intercom Channel Table for details)

5. Within a few seconds, the G4 will show a solid light for two

seconds, indicating that the two units are now paired, connected

and ready for use.

NOTES:
• If the Pairing process is not completed within two minutes the units will

return to Standby mode.

• When using an earlier scala rider model to serve as the Passenger unit

(e.g. a “Solo”, “FM”, “TeamSet

pro

” or a “TeamSet” Driver unit), Voice

Connect Intercom can only be initiated from the G4. However, you can

always initiate the Intercom manually also from the other scala rider

unit by pressing the button.

scala rider

PowerSet