Cardo SCALA RIDER G4 - Manual (Page 22)

Initiate Intercom calls from a G4
There are two ways to start an Intercom call with your paired headsets
while the G4 is in Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an Intercom
call will be established with both paired
devices, CHANNEL “A” and CHANNEL “B” (if
both are available).
CHANNEL BUTTON
CONNECT:
Single tap the CHANNEL
“A” or "B" Button to add or
remove the chosen channel
from an Intercom call.
10. CLICK-TO-LINK
Click-to-Link is the spontaneous “social” nature of your scala rider G4.
This unique feature will enable you to instantly initiate one-to-one
intercom calls with other G4 users in the near vicinity without going
through a pairing process in advance. Think of it as a private bike-to-
bike channel that you can set up on-the-fly with other scala rider G4
users that you spot next to a traffic light or along the road.
The Click-to-Link feature can of course be disabled at any time, blocking
any attempt by other G4 users to establish a spontaneous link.
USING CLICK-TO-LINK
Disable/Enable Click-to-Link: The feature can be turned on or off
via the Settings Customization Menu (see Section 4.2). By default,
this feature is DISABLED.
AUDIO SOURCES AND PRIORITIES
The different audio sources connected to the G4 are prioritized as
shown below, i.e. the higher priority source will always override and
interrupt the lower one.
For example, incoming mobile phone calls and GPS navigation
instructions will interrupt ongoing Click-to-Link calls, while incoming
Click-to-Link calls will interrupt the audio from the built-in FM Radio etc.
Click-to-Link established calls and Intercom calls have the same
priority: If one is in use, the other is unable to interrupt. Therefore, a
Click-to-Link request cannot interrupt an Intercom call in progress, and
vice-versa.
Higher Priority 1. Mobile Phone audio or GPS instructions (device
specific)
2. Intercom / Click-to-Link (same priority level)
3. A2DP audio source
4. FM Radio (built-in)
5. Auxiliary Line-In Port (for corded connection
e.g. MP3 players).

Lower Priority
IC (Intercom) Request Tone: If you are on a Click-to-Link call and
Rider A or Rider B try to connect to you for an IC Call, you will hear an
IC Request Tone while the other party will hear a rejection beep.
If your Click-to-Link connection is dropped for any reason and other
G4 users are nearby, new Click-to-Link connections may link up with
users other than your initial connection.
22 scala rider ® G4 PowerSet