Cardo SCALA RIDER G4 - Manual (Page 4)

2. CONTENTS OF THE RETAIL BOX
2 Helmet clamps (subject to the version purchased: Boom or Corded
Microphone)
Two speakers
Noise
canceling
microphone
Flexible
Boom
2 scala rider G4 units
Flip-up
antenna
Channel A
Button
• Connect to
Rider A
• MP3 Button
Channel B Button
• Connect to Rider B
• FM Radio Button
Mobile
Phone
Button
Volume Up /
Forward
Button Volume
Down /
Rewind
Button
Charging Jack
& Software
download port
2 Wall charger plugs
2 USB adapter cables
2 Allen wrenches
4 Velcro pads
2 MP3 cables
2 Glue plates
2 Pre-moistened Towlettes
2 Carry pouches
4 Microphone sponges
Flat sponge for full-face helmets and round sponge for open helmets
User Guide
The scala rider G4 PowerSet is also available in a cord-mounted
microphone version to better fit certain full-faced helmets with tight
chin sections.
IMPORTANT:
The scala rider G4 has been certified as waterproof and dustproof
(IP67) and is designed for use under moderate rain or snow conditions.
However, the cover lid protecting the Charging Jack should be kept
tightly closed at all times to prevent moisture from entering the device.
3. CHARGING THE G4
Make sure that both G4 units are fully charged for at least four hours
before initial use. Open the silicone cover protecting the Charging
Jack and Software Download Port.
Insert the USB cable to the wall charger and insert
the other end of the cable to the headset’s Charging
Jack. While charging, the Red Light turns on. When
charging is complete, the Red Light will turn off.
Sliding Panel
Silicone cover
MP3 Jack
(back of clamp)
LED
4 scala rider ® G4 PowerSet