Crestron electronic DIN Rail Control Processor DIN-AP2 - Manual (Page 19)

Crestron DIN-AP2 DIN Rail Control Processor
Hardware Hookup
Connect the
Device Make the necessary connections as called out in the illustration that
follows this paragraph. Refer to “Network Wiring” on page 13 before
attaching the 4-position terminal block connector. Apply power after all
connections have been made.
WARNING: Prior to connecting the device, turn off power at the circuit
breaker. Failure to do so may result in serious personal injury or damage
to the device. Restore power after all connections have been made.
CAUTION: Connecting this device to the wrong type of load, or short-
circuiting the load can cause severe product damage. Each load should be
tested to identify a short circuit condition prior to wiring the load to the
module.
NOTE: Install in accordance with all local and national electric codes.
NOTE: Use copper wire only.
When making connections to the DIN-AP2, use a Crestron power supply.
Operations & Installation Guide – DOC. 6662A DIN Rail Control Processor: DIN-AP2
• 15