Compaq 340622-002 - Manual (Page 50)

5-9 Troubleshooting
Compaq SLR Tape Drive User Guide
The following are examples of Stop messages:
■ ‘The tape device reported an error on a request to read data from tape.
Error reported: Bad data.’
■ ‘Tape device “Archive 1” reported an error on a request to write data to
tape. Error reported: Hardware error.’
■ ‘The device, \Device\Tape0, is not ready for access yet.’
To obtain detailed information on an error reported to the System Event Log,
use the following procedure:
1. Start the NT Event Viewer.
2. Select the Log drop-down menu.
3. Select System.
4. Highlight the entry for the tape drive to obtain the appropriate Event
Detail display.
Figure 5-3. A typical Event Viewer display