Cabletron Systems 2H253-25R User Manual
Page 55
Removing the Chassis Cover
Optional Installations and Mode Switch Bank Settings
B-3
To remove the chassis cover, proceed as follows:
1.
Disconnect the 2H253-25R from the network as follows:
a.
Unplug both power cords from the rear of the chassis.
b.
Disconnect all network cables attached to the 2H253-25R.
2.
If the 2H253-25R is rack mounted, remove it from the rack and remove the rackmount brackets
(refer to
3.
Use a Phillips screwdriver to remove the four screws attaching the cover to the chassis. (See
.)
4.
Remove the cover by sliding it back until it clears the front of the chassis and then lifting it
straight up and off the chassis.
To reinstall the chassis cover, perform the removal procedures in reverse.
TURN OFF THE 2H253-25R BY UNPLUGGING THE POWER CORD FROM THE
REAR OF THE CHASSIS.
AM HINTEN DES 2H253-25R STECHEI ABZIEHEN UM AUS ZU SCHALTEN.
APAGUE EL 2H253-25R DESENCHUFE EL CABLE DE LA UNIDAD.
TIP
Before performing step b, mark the cables connected to the 2H253-25R according to
their associated port numbers. This is recommended for ease of reinstallation.