beautypg.com

Lanview leds – Cabletron Systems 2H253-25R User Manual

Page 42

background image

Using LANVIEW

4-2

Troubleshooting

The LED MODE switch is located on the front panel of the 2H253-25R as shown in

Figure 4-1

.

This switch enables the user to change the function of the port LEDs. When the LED MODE
switch is moved to the left, the LEDs indicate the receive (RX) and transmit (TX) status of the
respective fixed ports (ports 1 through 24). When the LED MODE switch is moved to the right, the
port LEDs indicate whether the respective ports are operating in the standard or full duplex mode
(FDX) and if their operating speed (SPD) is 10 or 100 Mbps.

Table 4-1

describes the LED indications and provides recommended actions as appropriate.

Refer to the HSIM or VHSIM user’s guide for a description of the HSIM or VHSIM LED
indications.

NOTE

NOTE

NOTE

NOTE

The LED mode switch does not change the function of any LEDs on an installed HSIM
or VHSIM.

NOTE

NOTE

NOTE

NOTE

The terms flashing, blinking, and solid used in

Table 4-1

indicate the following:

Flashing indicates an LED is flashing randomly.

Blinking indicates an LED is flashing at a steady rate (approximately 50% on, 50% off).

Solid indicates a steady LED light. No pulsing.

Table 4-1

LANVIEW LEDs

LED

Color

State

Recommended Action

PWR

Off

Device electronics not
receiving power from power
supply(ies).

1. Ensure that the power cords are

plugged in correctly and that there is
power at the power source.

2. Contact Cabletron Systems for

assistance.

Green

Functional. Power supply(ies)
operating normally.

None.

Amber

Indicates loss of power supply
redundancy.

1. Ensure that the power cords are

plugged in correctly and that there is
power at the power source.

2. Contact Cabletron Systems for

assistance.