Keurig Cuisinart SS-700 - Manual (Page 19)

19
Cleaning the K-Cup ® Holder
1. The K-Cup ® holder is top-shelf
dishwasher safe (use low temperature
cycles in the dishwasher). To remove, lift
the handle to open the brewing
chamber. Grasp the top of the K-Cup
®
holder and pull towards you. After
cleaning, replace the K-Cup
® holder,
being sure to align the arrow on the
K-Cup
® holder rim with the arrow on the
brewing chamber.
2. Cleaning the Funnel – The Funnel can be
removed from the K-Cup Holder by
pulling on it until it pops off (see figure
27). The Funnel is top-rack dishwasher
safe. To replace it, just snap it back onto
the K-Cup Holder Assembly.
3. Cleaning the Exit Needle – The Exit
Needle is located on the inside bottom
of the K-Cup Holder Assembly. Should a
clog arise due to coffee grinds, it can be
cleaned using a paper clip or similar tool.
Remove K-Cup Holder (as shown in
figure 27). Insert the paper clip (see figure
28) to loosen the clog and push it out.
CAUTION: There are sharp needles
that puncture the K-Cup above and
below. To avoid risk of injury, do not put
your fingers in the K-Cup Assembly
Housing.
Cleaning the Water Reservoir
& Lid
Neither the reservoir lid nor the reservoir
should be put into the dishwasher. Clean
them with a damp, soapy, non-abrasive
cloth and rinse thoroughly. Do not dry the
inside of the water reservoir with a cloth, as
lint may remain.
Caution: Rinse the water reservoir
thoroughly after cleaning to ensure
that no cleaners or cleaning
solutions remain in this area, as they
may contaminate the Brewer’s
water supply.
figure 28
figure 27
figure 29