Keurig Cuisinart SS-700 - Manual (Page 14)

14
Stopping the Brew
Process
If for any reason you need to stop brewing
after the process has started, press the
power switch on the rear right side of the
Brewer to turn the Brewer off. The flow of
coffee, tea or hot cocoa will stop, the heater
will shut off, and the blue lights illuminating
the control panel and reservoir will turn off.
Note: You may get less coffee, tea or hot
cocoa in your cup during your next brew. In
order for your next brew to be the volume
you have selected, we recommend that you
perform a rinse cycle after a terminated
brew.
Adding Water
The Control Panel will indicate when the
water level in your reservoir is low or if the
Reservoir has been removed by displaying
the words “ADD WATER”. The blue light in
the Reservoir will also blink when water
needs to be added. When “ADD WATER” is
displayed, the Brewer will not allow you to
brew.
The Water Reservoir can be filled in
two ways:
1. Lift off the Reservoir Lid and pour water
directly into the Reservoir while it is still
attached to the Brewer, then replace
the Lid.
2. Remove the Reservoir from Brewer by
first removing the Lid from the Reservoir
then lifting the Reservoir straight up and
away from Brewer. Fill with water, place
the Reservoir back on the Brewer, and
replace the Lid.
IMPORTANT: Do not remove the Water
Reservoir during the brewing process.
Purging the Brewer
If your Brewer has not been used for more
than one week, we suggest purging the
water from the inner tank.
1. If there is water in the reservoir, discard
the water, then rinse and refill with fresh
water. Place the reservoir back on the
Brewer and replace the lid. (If there is no
water in the reservoir, simply fill.)
2. Be sure the Brewer is turned on. Raise
and lower the handle on the Brewer
without inserting a K-Cup
® .
3. When the control panel displays READY,
dispense 12 oz. of hot water by
selecting the 12-oz. cup size and hot
water.
4. Repeat this process two more times to
completely replace the water in the
inner tank.