Jaypro Sports BBC-SPDKT - Manual (Page 6)

Rev - B Page 6 of 13
5) Attach the adjustment end of the three cables to the building structure as shown.
Extend the turnbuckles to their maximum length for each cable. Loosen the two
cable clamps and remove as much slack from the cable as possible. Tighten the
cable clamps using a 7/16” nut driver. Using the turnbuckles tighten each cable.
Cut any excess cable using a bolt cutter.
Figure 4: Standard Building Attachment On Adjustment End
Adjust the cables using the 1/2" x 12”
turnbuckles as needed to minimize sag.
Caution: Over tightening the cables may result in damage to the wall or support structures.