Jaypro Sports BBTFSM-70 - Manual (Page 9)

Rev:- Page 9 of 10
WICKET ASSEMBLY: (CONTINUE)
1) Using two people lift and insert each frame into an associated pair of sleeves.
2) Roll out net under the frame, spreading it out flat. Center the net inside the
frame.
3) Lay the three cables over top of the net, one over each edge and along the
middle. Extend the end of each cable, with the tightened cable clamps, about
6” from the edge to the net.
4) Attach the cables to net using the plastic zip ties, placed every 12”.
5) Extend the turnbuckles and attach one turnbuckle to each cable end, as shown
in Figure 6.
6) At the other end, adjust the length of each cable so the thimble is about 12”
from the end of the net.
7) Using a stepladder(s) attach each of the three turnbuckles to eyebolts in the
end frame.
8) Working towards the other end, raise and attach the net and cable to each of
the outer eyebolts using the spring clips (#4).
9) Attach the end of each of the outer cables to the eyebolts in the end frame.
10) Working from inside the net, lift and attach the center cable and net to each of
the frames.
11) Center the net on the frame and tighten the turnbuckles. Tie off the ends of
the net to the eyebolts.