Jaypro Sports BBTFSM-70 - Manual (Page 8)

Rev:- Page 8 of 10
WICKET ASSEMBLY:
1) Assemble frames on a flat level surface, as shown in Figure 3-A. Each frame
consists of two uprights (#1) and one crossbar (#2). Secure frame sections
using the self-drilling screws (#9). Note: The holes in the two end crossbars
should be horizontally oriented, but the remaining crossbars should have the
holes oriented vertically. Refer to Figure 3-B.
2) Install three eyebolts (#5) in each frame, as shown in Figure 4. Space the
outer eyebolts at either 12 ft or 14 ft apart, depending on the width of the net.
Note: the eyebolts will be pointing down on the center frames once the frames
are installed. On all except one of the end frames, attach one spring clip (#4)
on each of the eyebolts.
3) Make up one end of each of the three cables, as shown in Figure 5. Tighten
the cable clamps using a 7/16” nut driver.
4) Make up the other end of each cable leaving the cable clamps hand tight, as
the overall length may need to be adjusted.