Jas-Audio PLATO - Manual (Page 9)

system setup. We highly recommended the selected-custom-made speaker and jumper cables.
Each speaker has six terminals on the rear panel. The terminals ar s that accept either spade lugs,
pins and banana plugs. Make sure the cables connected to both speakers are in phase with each other: connect the
(+) binding post on the amplifier to the (+) terminal on the speaker, and the (-) binding post on the amplifier to the
(-) terminal on the speaker. In most configurations, Plato’s speaker jumper cables need to be attached at the Tri-
wiring crossover network (see picture). The default setting captured as following clips:
e binding post
Inspection after unpacking
The super tweeter of JAS Plato speaker (@ backside) is protected with a
Transparent-Protective-Sheet to prevent damaging on the Tweeter Unit.
Customers are recommended to remove the Transparent-Protective-
Sheet immediately before using or installing on your listening system!
Page 9 of 12
http://www.jas-audio.com