Intex ZS8110 Saltwater System - Manual (Page 16)

(187PO) MODEL ZS8110 OZONE & SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
187
PO
SAVE THESE INSTRUCTIONS
English
Page 16
MAINTENANCE
IMPORTANT
Unplug the power cord before cleaning your system. Also close the plunger valves
on your pool or insert the black hat-like plugs in the strainer opening to prevent
water spillage. After completing all maintenance tasks, you must plug the power
cord back in and open the plunger valves or remove the plugs.
Ozone generator assembly replacement:
1. The “REPLACE O
3
GENERATOR” light on the panel will turn red when the Ozone
generator assembly need to be replaced. In a counter-clockwise motion, unscrew the four
screws with a phillips screwdriver (tools not included).
2. Remove the back cover, unplug the Ozone generator assembly cable.
3. Pull out the Ozone generator assembly.
4. Replace with a new Ozone generator assembly by pushing it in along the rails, and
reconnect Ozone generator assembly cable back.
5. Reverse steps 1 and 2 to replace the other parts.