Canon DR-6030C - Manual (Page 87)

Software Setup 81
Chapter 3
☞ The color range within the shaded (cross-hatched) area is dropped out or
enhanced.
☞ You can move the shaded area by dragging with the mouse.
☞ You can change the specified color range by dragging the edges of the
shaded area.
☞ Because your operating environment affects the colors you specify on
screen, they may not match those actually dropped out or enhanced: that is,
the colors you specify may not match those processed.
[Others] Tab Sheet
The settings on the [Others] tab sheet are different for the ISIS and TWAIN
drivers. Also, some settings may be disabled depending on the mode settings on
the [Basic] tab sheet. Refer to “Mode-Dependent Function Limitations,” on p. 68
for details.
ISIS driver TWAIN driver
[Reverse side]
Scanning occurs as follows depending on the scanning side settings.
☞ When this check box is selected and the scanning side is set to [Simplex],
only the back of each page is scanned.
☞ When this check box is selected and the scanning side is set to [Duplex] or
[Skip Blank Page], the back of each page is scanned first, followed by the
front.
[Rapid Recovery System] Check Box
If a paper jam causes paper transport to stop while scanning, scanning stops
without sending an error notification to the application program. After fixing
the cause of the stoppage, you can continue scanning with the standard
operations.