Fpga configuration, Launch impact – Connect Tech 104 User Manual
Page 13
Connect Tech FreeForm/PCI-104 User Manual
Revision 0.00
13
FPGA Configuration
To configure the FPGA via JTAG, connect the JTAG programming cable to
P2
ensuring that all JTAG
signals align correctly. It is important to note that
P2
also has the TRST signal on pin 1, which is not part
of Xilinx’s Parallel or USB programming cables.
Launch Impact
1)
Open iMPACT, and select create a new project
2)
Select configure devices using boundary scan. iMPACT will scan the JTAG chain, and identify
three devices. The first device will be the FPGA.