Cabletron Systems SEH100TX-22 - Manual (Page 31)

Powering Up and Stacking the SEH
SEH100TX User’s Guide 4-7
5. Attach the interconnect cable to the “IN” port on the rear panel of the
SEH as shown in Figure 4-5.
Figure 4-5 Stacking the SEH and SEHI
6. Attach the other end of the interconnect cable to the “OUT” port on the
rear panel of the hub at the bottom of the stack.
7. Repeat steps 3 through 6 until all SEH hubs are connected.
!
CAUTION
Do not leave an interconnect cable connected at only one end
during network operation. Corrupted data may result.
100BASE-TX HubSTACK
Interconnect Cable
REAR VIEW
SEHI Managing 4 SEH Non-Intelligent Hubs
OUT
SEHI100TX INTERCONNECT
IN
SEHI 100TX -22 100BASE-TX HUB WITH LANVIEW®
OUT
SEH100TX INTERCONNECT
IN
SEH 100TX -22 100BASE-TX HUB WITH LANVIEW®
OUT
SEH100TX INTERCONNECT
IN
SEH 100TX -22 100BASE-TX HUB WITH LANVIEW®
OUT
SEH100TX INTERCONNECT
IN
SEH 100TX -22 100BASE-TX HUB WITH LANVIEW®
OUT
SEH100TX INTERCONNECT
IN
SEH 100TX -22 100BASE-TX HUB WITH LANVIEW®
1511_07