CyberPower Systems CPS525SL - Manual (Page 18)

CPS525SL / CPS725SL
Guaranteed Uninterruptible Power System
16
The Limited Warranty and the Power
Control Guarantee are the only and
the exclusive express warranty of
CyberPower with respect to the
Product. This exclusion of other
express warranties applies to written
and oral express warranties. Any
Implied Warranty of Merchantability or
for Fitness for a Particular Purpose, if
applicable to the Product, is limited in
duration to the period of ownership by
the Initial Customer. This provision
shall NOT create any Implied
Warranty or Merchantability or of
Fitness for a Particular Purpose that
would not Otherwise apply to the
Product. NOTE: Some States do not
allow limitations on how long an
implied warranty lasts, so the above
limitation may not apply to you.
LIMITATION: THE LIMITED
WARRANTY AND THE POWER
CONTROL GUARANTEE DO NOT
COVER
The Limited Warranty and the Power
Control Guarantee are intended to
exclusive rights and remedies and
replace any other rights, to the extent
allowed by law.
As to CyberPower products, the
Limited Warranty does not cover or
apply to: Misuse; modification;
operation or storage outside
environmental limits for the Products;
in transit, in shipment, or in storage,
damage or deterioration; improper
operation or maintenance; use with
items or equipment not designed or
intended for use with the Product.
As to Connected Equipment, the
Power Control Guarantee covers only
damage within the specific terms of
the Power Control Guarantee to
Connected Equipment (and only up to
the applicable aggregate ceiling
amount). The Power Control
Guarantee does not cover damage to
Connected Equipment or apply if the
product has been operated in a failure
mode or not in compliance with
CyberPower operating instructions
and manuals. Or if the Connected
Equipment has been operated in a
failure mode or not in compliance with
the instruction and manuals of its
manufacturer/vendor.
The Limited Warranty and the Power
Control Guarantee Do Not Apply
Unless The Initial Customer:
Has properly connected the Product
and the Connected Equipment to
properly wired and grounded
outlets/power supplies (including compliance with electrical and safety
codes of most current National
Electrical Code, ANSI/NFPA 70),
without the use of any adaptors,
extension cords, or other connectors.
Has provided a suitable and proper
environment for use and installation
of the Product and Connected
Equipment.
Has properly installed and operated
the CyberPower Product and
Connected Equipment.
CyberPower Does Not Cover or
Undertake Any Liability in Any Event
for Any of the Following:
Loss of or damage to data, records,
or software; restoration of data or
records; or reinstallation of software.
Damage from causes other than AC
Power Line Transients, spikes, or
surges on properly installed,
grounded and code-compliant 120
volt power lines in the United States
and Canada; transients, surges, or
spikes on standard telephone land
lines, PBX telephone equipment lines
or Base 10/100T Ethernet lines, when
properly installed and connected.
(This exclusion applies, for example,
to fluctuations in data transmission or
reception, by CATV or RF
transmission or fluctuations, or by
transients in such transmission).
Damage from any circumstance
described as excluded above with
respect to the Product.
Damages from fire, flood, wind, rain,
rising water, or leakage or breakage
of plumbing; from abuse, misuse, or
alteration of either the Product or the
Connected Equipment.
Exclusion of Consequential and Other
Damages. The sole and exclusive
remedies of the Initial Customer are
those provided by the Limited
Warranty and Power Control
Guarantee. CyberPower excludes
any liability for personal injury under
the Limited Warranty and Power
Control Guarantee. CyberPower
excludes any liability for direct,
indirect, special, incidental or
consequential damages, whether for
damage to or loss of property, loss of
profits, business interruption, loss of
information or data, EXCEPT FOR
(AND ONLY FOR) the specific limited
agreement of CYBERPOWER to
provide certain warranty benefits
regarding “Connected Equipment”
under the “CYBERPOWER Power
Control Guarantee”.
NOTE: Some States or Provinces do
not allow the exclusion or limitation of
incidental or consequential damages,
so the above limitation may not apply
to you.
DO NOT USE FOR MEDICAL OR
LIFE SUPPPORT EQUIPMENT OR
OTHER HIGH RISK ACTIVITIES.
CyberPower does not sell the
Products for use in high-risk activities.
The Product is not designed or
intended for use in hazardous
environments requiring fail-safe
performance, including the operation
of nuclear facilities, aircraft navigation
or communication systems, air traffic
control, weapons systems, life
support or medical applications or for
use in any circumstance in which the
failure of the Product could lead
directly to death, personal injury, or
severe physical or property damage,
or that would affect operation or
safety of any medical or life support
device (collectively, “High Risk
Activities”). CyberPower expressly
disclaims any express or implied
warranty of fitness for High Risk
Activities. CyberPower does not
authorize use of any of its products
use in any High Risk Activities. ANY
SUCH USE IS IMPROPER AND IS A
MISUSE OF CYBERPOWER
PRODUCTS.
The Limited Warranty and the Power
Control Guarantee are governed by
the laws of the United States and the
State of Minnesota, without reference
to conflict of law principles. The
application of the United Nations
Convention of Contracts for the
International Sale of Goods is
expressly excluded.
Contact Information: CyberPower’s
address is 5555 12th Ave East, Suite
110, Shakopee, MN 55379 and its
phone number is (952) 403-9500.
CyberPower is the warrantor under
this Limited Warranty. You may also
contact CyberPower on the Internet at
www.cyberpowersystems.com.