beautypg.com

Additional information, Troubleshooting – Philips CD 750/00B User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

ADDITIONAL INFORMATION (

g

|)

MAINTEIMAIMCE

TECHNICAL DATA

The CDs

• Never write on the printed side of a CD.
• Do not attach any stickers to the CD.

• Keep the shiny surface of the disc clean.

Use a soft lint-free cloth and always wipe the

disc in a straight line from centre to edge.

• Never use cleaning agents for conventional

records,

• Detergents or abrasive cleaning agents

should not be used either.

The player

• A chamois leather slightly moistened with water is sufficient

for cleaning the player.

• Do not use cleaning agents containing alcohol, spirits,

ammonia or abrasives.

RECYCLING

Please observe the local regulations regarding the disposal of

packing materials, exhausted batteries and old equipment.

7, All redundant packaging material has been omitted. We have

done our utmost to make the packaging easy separable into

three mono-materials; cardboard (box), expandable polystyrene

(buffer) and polyethylene (bags, protective foam sheet).

2. Your set consists of materials which can be recycled if dis­

assembled by a specialized company.

3.

Do not dispose of exhausted batteries with your household

waste.

Typical Audio Performance

Frequency range;.................................................. 2 Hz - 20 kHz

Amplitude linearity;............................... 0.03 dB (20 Hz - 20 kHz)

Phase linearity:............................................. 1° (20 Hz - 20 kHz)
Dynamic range:....................................................95 dB (1kHz)

Signal-to-noise ratio:........................................... 105 dB (1 kHz)
Channel separation:.............................................105 dB (1kHz)

Total harmonic distortion:....................................0.002% (1kHz)

D/A conversion:........................................ Bitstream conversion

Audio output level:........................................................... 2 Vrms

Impedance PHONES socket:.............................. 30 - 600 ohms

Power supply
Mains voltage and frequency:

see the type plate on the rear of the player

Power consumption;............................................. 10 W approx.

Safety requirements:........................................................ lEC 65

Cabinet

Material/finish:......................................... metal and polystyrene
Dimensions (w x h x d):.............................435 x 106 x 300 mm

Weight:..................................................................4 kg approx.

Subject to modi'fication

This Compact Disc piayer complies with radio interference

requirements as laid down in EC regulations.

D)

C

lU

TROUBLESHOOTING

It a fault occurs, run through the points listed below before taking your player for repair.
If the fault remains, try to clear it by

switching the piayer off and on again.

If this also fails to help, consult your dealer.

Under no circumstances should you repair the player yourself as this will invalidate the guarantee!

SYMPTOM

POSSIBLE CAUSE

Playback of the CD does not start or
interruption of playback.

j - The CD has been loaded upside down.

I

- No CD inserted.

- The CD is badly scratched or dirty.
- Moisture condensation on the lens.

- Sound skips (at the same part).

The CD skips tracks.

- Playback does not start from the first track.

- The CD is dirty.

- The CD is damaged or dirty.

PRG (programme) or SHUFFLE activated.

REMEDY

• Reload the CD, label side up.
• Insert a CD, label side up.
• Clean the CD with a soft, lint-free cloth.
• Leave the CD player in a warm

environment until the moisture evaporates.

Clean the CD with a soft, lint-free cloth.

Replace or clean the CD.

Switch off REPEAT or clear programme.

- No sound or bad sound.

- Loose or wrong connections.

- Strong magnetic fields near the CD

player.

Check connections.

Find another place for the unit or

change connections.

Volume IS too low.

- Sound level has been adjusted too low

with the -VOLUME + keys on the

remote control.

Adjust sound level.

No sound or bad sound on

headphones.

- Level control set to - position.
- Headphones plug is dirty.

• Set level control
• Clean plug.

Remote control does not function.

- Batteries are empty.

Replace the batteries.

Remote control commands are not

properly received.

- The distance between remote control

and CD player is larger than 10

metres.

• Use remote control receiver EM

2200/2201.

• Reduce the distance between remote

control and CD player.

13

This manual is related to the following products: