Philips AJ3740 - Manual (Page 7)

SEHING DATA MANUALLY RADIO
TIME ZONE SEHING
<2
*e>
This feature allows you to set the clock display with up to 2 hours
difference from the radio controlled clock time.
1. Press the WEEKEND SLEEPER/ timezone button once.
If the display shows the time zone setting 00:00, no time
difference has been selected.
2. Press TUNING / or briefly to select up to 2 hours
difference.
3. Press the WEEKEND SLEEPER/ timezone button twice if you
wish to exit the time zone display immediately.
I AUTOMATIC SUMMER TIME OR STANDARD TIME
You can set the clock to Auto to automatically adjust to summer
time using the radio controlled signal, or where there is no
seasonal time difference you can select the standard time mode
Std.
1. Press the WEEKEND SLEEPER/ timezone button twice.
The display will either show Auto or Std.
2. Press TUNING / h < or briefly to select Auto or Std.
-* If you have selected Auto during summer time, summer
will appear in the display.
3. Press the WEEKEND SLEEPER/ timezone once if you wish to
exit the time zone display immediately.
RADIO RECEPTION
When you switch on the radio, the last preset or station tuned to
will be heard,
1. Press RADIO ON to switch on the radio mode.
—The radio frequency and waveband appear in the display for
10 seconds before reverting back to the clock display. Press
RADIO ON again if you want to view the radio display.
2. Adjust the BAND switch to select the waveband.
3. Tune to the station either manuaiiy, automatically or by
using the presets.
To improve radio reception
FM: extend the pigtail wire at the back of the set
completely for optimum reception.
MW/LW: uses a built-in antenna. Direct the antenna by
adjusting the position of the set.
4. Adjust the sound using the VOLUME control.
5. To switch off the radio, press ALARM RESET/RADIO OFF.
—The display reverts to showing the clock time.
\L CLOCK RADIO
ALARU RESET SUUtiSEB
0
Q
o
Rfio'.ooM ^