Philips AJ3740 - Manual (Page 6)

SEHING DATA MANUALLY
m
s CO
SEHING THE TIME, DATE AND YEAR MANUALLY
General
The data for the clock time, date and year need to be entered
separately.
Setting the time manually
1. If necessary, press the REPEAT ALARM/ time date button
until the display shows the time mode.
- If the time display 00:00 is already flashing, go to step 3.
2. Press SET to activate the setting mode.
—The time display will start flashing.
3. Use TUNING / r« or to adjust the hours and minutes.
- With TUNING / r« or pressed, the display will
increase or decrease the minutes and hours rapidly and
continuously.
- Press TUNING/«◄ or briefly and repeatedly to adjust
the time minute by minute.
4. Press SET when you have reached the correct time.
Setting the date and year
Both the day and the year display modes will be shown for 10
seconds, before reverting back to the clock time display.
The date modes refer to the month and day. E.g. December 31st
will be displayed as 12--31.
• There is no need to adjust the days of the week ( mon -SUN) as
this is done automatically after you have set the date and the
year correctly.
/. Press the REPEAT ALARM/ time date button repeatedly until
the display shows the mode you wish to set (date/year).
2. Use TUNING / r« or to adjust the month and day and the
year.
- With TUNING / r« or pressed, the display will increase
or decrease the days/years rapidly and continuously.
- Press TUNING / 1 -« or»>i briefly and repeatedly to adjust
the display day by day or year by year.
- Press SET when you have reached the correct date and
year.
3. The date and year is now set. Press the REPEAT
ALARM/ time date button if you wish to return to the clock
display immediately.