Alarm on/off – Philips AJ3740 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ALARM on/off

SWITCHING OFF THE ALARM

There are two ways to switch off the alarm. Unless you cancel the

alarm completely, the ALARM RESET will be automatically

selected after 60 minutes, from the time your alarm first sounds.

Note: During an alarm call or repeat alarm, only the ALARM

RESET/RADIO OFF and REPEAT ALARM/nwE

date

controls on the set will operate.

Alarm reset

If you want the alarm mode to be stopped immediately but also

wish to retain the same alarm setting for the following day;

1. Press ALARM RESET/RADIO OFF.

—You will hear a long beep tone confirm that the ALARM

RESET has been activated.

Repeat alarm

This will repeat your alarm call at approximately 9 minute

intervals.

1. During the alarm call, press REPEAT ALARMA

imedate

— After 9 minutes the alarm will call again.

2. You can press REPEAT ALARM/

timedate

again as often as

desired.

— The alarm mode indication J] or O in the display will

flash throughout the time when REPEAT ALARMA

imedate

is active.