beautypg.com

Radio controlled time reception, Installation sehing data automatically – Philips AJ3740 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

INSTALLATION

SEHING DATA AUTOMATICALLY

Power breakdown

In the event of a power failure the set will be completely

switched off. Disconnect the set first and re-plug after 3

seconds or more. All settings will remain in the memory, but you

will need to reset the clock time, date and year. For /00 and /05

versions, you may leave the set to reset automatically by radio

controlled clock signal.

For users in the U.K.: please follow the Instructions on page 2

Connecting headphones / loudspeakers

Connect headphones / loudspeakers with a 3.5 mm plug into the

ii socket.

-*■ The built-in loudspeaker will now be muted.

Illumination brightness

Adjust the BRIGFITNESS CONTROL to change the brightness of

the display.

There are two settings: BRIGHT -* DIM

Clock display

The time is displayed using the 24 hour clock.

RADIO CONTROLLED TIME RECEPTION

Your clock is equipped with a special long wave radio receiver

with which the time and date are set automatically and

accurately. As soon as the set is connected to the mains, the time

display will flash. If the radio controlled clock signal is strong, fi

will appear within 10 seconds and the time will be set

automatically within 3 minutes.

• The signal £ may disappear or blink during normal

operation as a result of electrostatic interference (see

Troubleshooting).

• If £ does not appear, the radio controlled clock transmission

is too weak and you will need to set the clock manually to run

on normal quartz time.

• When the radio time transmission for your time zone is duly

received, this information will replace any manually set data

on time and date.

To improve radio controlled clock signal reception:

1. Place the set at a window away from metal objects such as

aluminium sunblinds and panelling.

2. Make sure that the antenna is placed securely and

horizontally on a flat surface.

3. Adjust the position of the antenna gradually: wait for the £

to blink each time you rotate the antenna. It may take 2 or 3

minutes to adjust the antenna for automatic setting of the

clock.