Philips AQ 6350 - Manual (Page 3)

English
CASSEHE PLAYBACK MAINTENANCE
During cassette playback the LINE IN socket@ should not be
occupied.
• Press STOP-EJECT ■ and insert a cassette Ifig. 4t, for
playback, any cassette type can be inserted.
• Press PLAY ►and playback will start.
• Adjust the sound with the controls VOLjume), BASS and
TREBLE.
• To vary the the musical pitch of the cassette piayback, use the
SPEED CONTROL (also see 'SPEED CONTROL').
• To stop, press STOP-EJECT ■.
- The set is then switched off.
Reproduction is possible through:
- the buiJt-in loudspeaker.
- a loudspeaker box connected to the LS "3 socket ©. The
recorder loudspeaker is then switched off.
- a headphone connected to the EAR socket @. The loud­
speaker is then switched off.
- an amplifier, radio or recorder connected to the EAR socket©.
The loudspeaker is then switched off.
Important! The EAR 2 output signal Is affected by the position of
the controls VOLIumel BASS and TREBLE, so set these controls
to their midposition.
SPEED CONTROL____________________________
Using SPEED CONTROL, the tape speed of the cassette playback
can be changed slightly, in consequence of which the musical
pitch and rhytm of the cassette playback will be changed as
well.
The SPEED CONTROL is only operative during cassette playback,
not during cassette recording.
FAST WINDING AND REWINDING______________
• Press F(ast) F(or)W(ar)D ►► or ■« REWIND.
• Fastwinding/rewinding can be stopped by pressing
STOP-EJECT«.
END OF CASSETTE___________________________
When the end of the tape is reached during recording, playback
and fast fonward winding or rewinding, the pressed recorder
buttons will automatically be released.
SAFEGUARD AGAINST ERASURE_______________
• Keep the cassette side to be safeguarded in front of you
Ifig. 5f and break out the left tab.
- Now recording on this side is not possible any more.
• You can render this safeguard ineffective by covering the
aperture now existing with a piece of adhesive tape.
Clean the parts indicated in fig. 6 after every 50 hours of
operation or, on average, once a month:
• Open the cassette holder by pressing STOP-EJECT «.
• Use a cotton bud slightly moistened with alcohol or a special
head cleaning fluid.
• .^Press PLAY ► and clean the rubber pressure roller ® Ifig. 6).
• Then press PAUSE and clean the capstan ©,
recording/playback head ® and erase head ®.
• After cleaning, press STOP-EJECT «.
• Cleaning of the heads ® and ® can also be done by playing
a cleaning cassette through once.
Do not expose the set, batteries and cassettes to rain, moisture,
sand, or to excessive heat e.g. from heating equipment or in
motor cars parked in the sun.
The type plate is located on the base of the set.
This product complies with the radio interference requirements
of the European Community.